How to maintenance the wood router?

Maintenance points of woodworking engraving machine

1, Checking the machine rack before  power on machine, whether there is anything in rack gear and guide.

2 check the water level of the vacuum pump every day and keep the water level

3, the machine spindle pump must add 000# grease

4, grease in row drilling bag, add 5CC grease every five days,  use row drill special butter

5. Clean the rack, guide rail and Z shaft screw at the end of each day and spray rust remover

6 clean the guide rail every day, and press the grease pump to lubricate the guide rail. The fingers touch each rail, and the fingers have grease and grease in place

7 vacuum pumps clean up and replace water every week

8, winter boot press F4, row drill bag preheated 4-5 minutes

9 after the end of the daily work, should clean up the distribution cabinet and internal electrical parts, avoid causing short circuit and cause electric fire!!!